Turning Off Smart Alarm
1. Display the current time screen.
l
Watch Mode
2. Hold down (C) for at least two seconds.
This enters the Control Mode.
3. Use (C) to select [SETTING].
4. Press (A).
This displays the setting menu screen.
5. Use (C) to move the pointer to [WATCH
SETTINGS].
6. Press (A).
This displays the watch setting screen.
7. Use (C) to move the pointer to
[SMART
ALARM].
8. Press (A).
9. Use (C) to select
[
OFF].
10. Press (A) to complete the setting
operation.
After the setting operation is complete, a
check mark appears for a few seconds,
and then the watch setting screen re-
appears.
11. Hold down (D) for at least one second to
return to the current time screen.
Note
●
If you do not perform any operation for
two or three minutes while the smart
alarm setting screen is displayed, the
watch automatically returns to the
current time screen.
Measuring Your
Heart Rate
While wearing the watch on your wrist, you can
use it
to perform approximate measurement of
your heart rate.
You can use heart rate measurements to
monitor your daily health and to make your
training more effective.
Important!
●
For more accurate measurement
results, configure your profile settings
before using the heart rate
measurement function.
l
Creating Your Profile
●
Be sure to affix the watch to your wrist
before starting a heart rate
measurement operation. Starting a
measurement operation and then
affixing the watch to your wrist may
make correct measurement
impossible.
Checking Your Current Heart
Rate
The HEART RATE (heart rate measurement)
function lets
you check your current heart rate.
1. Display the current time screen.
l
Watch Mode
2. Use (C) to select
[
HEART RATE].
3. Press (A).
This displays the current heart rate
screen.
●
Each press of (C) toggles between the
value screen and graph screen.
Value Screen
Watch Operation Guide 3516
32
To Next Page
Loading...
Need help?
General