E-7
Layering Two Tones
Use the following procedure to layer to two tones, so
they sound at the same time.
1
Simultaneously press the TONE buttons of
the two tones that you want to layer.
Example: Press GRAND PIANO 2 button and
STRINGS button at the same time.
• The tones are now layered.
2
After you are finished using the layered
tones, press the one of the TONE buttons
again to unlayer them.
Adjusting the Volume of Layered Tones
1
While holding down the CONTROL
button, use the keyboard keys shown below
to adjust the volume of the layered tones.
+ : Raises the volume
– : Lowers the volume
Playing with Different Tones
412A-E-009A
GRAND PIANO 2
STRINGS
▲
C
1
▲
C
2
▲
C
3
▲
C
4
▲
C
5
▲
C
6
▲
C
7
▲
C
8
–
+
Assigning Different Tones to the Left
and Right Sides of the Keyboard
You can assign different tones to keys on the left side
and the right side of the keyboard.
1
Press the TONE button of the tone you want
to select for the high (right) range.
Example: GRAND PIANO 2
2
Press the SPLIT button.
• This causes the SPLIT indicator lamp to light.
3
Press the TONE button of the tone you want
to select for the low (left) range.
• The keyboard is now split between the two
tones.
Example: STRINGS
4
After you are finished using the split
keyboard, press the SPLIT button again to
unsplit it.
• This causes the SPLIT indicator lamp to go out.
NOTE
You can also perform a kind of “quick split” operation
using the following key operations.
• Press the SPLIT button.
➠ Acoustic Bass (built-in tone)
• Hold down the CONTROL button and press the
SPLIT button.
➠ Ride Aco Bass (built-in tone)
Split Point
STRINGS GRAND PIANO 2
To Next Page
Loading...
Need help?
General
