Digital Piano Operations
EN-16
■ To unlayer the keyboard
1.
Use the bp^ button to cycle through settings
until the “^CTRL” indicator to the right of the
button is lit.
2.
Touch cl LAYER so the “LY” indicator
disappears from the display.
You can use the lower range and upper range of the keyboard
to sound two different tones. When the keyboard is split
between a left side and a right side range, the tone assigned
to the lower (left side) range is the “Lower part tone”, which is
referred to as the “Lower tone” in this manual. The tone
assigned to the upper (right side) range is called the “Upper1
tone” or “Upper2 tone” (when the keyboard is layered with the
Upper2 tone).
Under initial default settings, the lowest note of the upper
range (split point) is at F{3.
■ To split the keyboard between two different
tones
1.
Use the procedure under “To select a tone”
(page EN-15) to select the upper range
(Upper1) tone.
2.
Use the bp^ button to cycle through settings
until the “^CTRL” indicator to the right of the
button is lit.
3.
Touch ck SPLIT to enable the split function,
which is indicated by “SP” on the display.
4.
Use the bp^ button to cycle through settings
until the “^TONE” indicator to the right of the
button is lit. Next, perform the operation under
“To select a tone” (page EN-15) to select the
Lower tone.
• To use split and layer at the same time, perform the
procedure above and then continue with steps 2 through 4
under “To layer two tones” (page EN-15).
• You can individually adjust the volumes of the Lower part,
Upper1 part and Upper2 part, and configure other part
settings. For details, see “Configuring Layer and Split
Settings” (page EN-17).
■ To change the split point
1.
Use the bp^ button to cycle through settings
until the “^CTRL” indicator to the right of the
button is lit.
2.
Hold down ck SPLIT as you press the
keyboard key you want to specify as the lowest
note of the upper range (right) keyboard. This
makes it the split point.
3.
Release ck SPLIT.
This sets the split point.
Splitting the Keyboard Between Two Tones
[
TONE
]
LOTHERS
T : 120 SP
059 :Acous .Bass 1
Split enabled indicator
“Lower” indicator
[
CTRL
]
KNOB
S P . P O I N T : F 3
|
F # 3
01 :Fi l ter
To Next Page
Loading...
Need help?
General
