EN-54
Digital Piano Operations
3.
Display the name of the parameter whose setting you want to change.
• For example, to display the “Chorus Type” parameter, you need to navigate through multiple directories in the following
sequence: “SOUND” (directory) 3 “EFFECT” (directory) 3 “Chorus Type” (parameter). Perform the procedure below.
(1) Use the bk U and bl I buttons to display “SOUND” and then touch bm ENTER.
• This enters the “SOUND” directory.
(2) Use the bk U and bl I buttons to display “EFFECT” and then touch bm ENTER.
• This enters the “EFFECT” directory.
(3) Use the bk U and bl I buttons to display “Chorus Type”.
• To exit the current directory and return to the level above it, touch bp EXIT.
4.
After displaying the parameter name, touch bm ENTER.
This displays the parameter setting editing screen, with the parameter’s current setting shown in line 3.
5.
Use the bk – and bl + buttons, or cm (K1) knob to change the setting.
• To return to the initial default setting, touch bk – and bl + at the same time.
6.
After the setting is the way you want, exit the parameter editing screen by touching bp EXIT.
7.
To exit the FUNCTION Mode, hold down bp EXIT until “[FUNCTION]” disappears from the display.
• The above steps are the basic procedure of the FUNCTION Mode. Some items included in the FUNCTION Mode require
operations that are different from those above. Refer to the information below.
For information about this item: Go here:
Operation Lock “Using Operation Lock” (page EN-59)
Setting Reset “To return all Digital Piano settings to their initial factory defaults (Setting Reset)” (page
EN-60)
Factory Reset “To return all Digital Piano settings and data to their initial factory defaults (Factory
Reset)” (page EN-60)
[
FUNCT I ON
]
–
Tone
+
Cho r us T
yp
e
To Next Page
Loading...
Need help?
General
