E-109
Useful features
Advanced programmings and registrations
Programming further clerk functions
This section explains how you can set further programming for clerks such as
setting clerks’ secret number, setting the register in training mode or setting com-
mission rates given to clerks. In the training mode, the register operates normally
but the results will not be stored in the memory. You can use this feature for
getting to know the operations of the cash register for yourself or for newly hired
clerks.
Setting check number for clerk interruption and clerks’ secret number
Step Operation
1 Turn the Mode switch to PGM position and select [System
Setting] then press F key.
>▪▪▪▪▪>F
2 Enter 3 and press o key to set the register in the
programming mode.
3o
3 Enter 2 -digit clerk number followed by 07. The “07” is the
identication code for further program of clerks. Then press
o key. The example on the right is for programming to
clerk number 10.
1007o
(Clerk no.)
4 Enter the program code and press F key. The ex-
ample on the right is for setting check number “123456” for
clerk interruption and clerk’s secret number “7890”.
123456789
(program code)
F
5 If you wish to set the same program to the next clerk
number, perform the step 4 again. When you set to another
clerk (not next clerk number), repeat steps 3 and 4.
6 Press o key to complete the settings.
o
Program code for check number for clerk interruption and clerks’ secret number
Description Selection Program code
Must be “000000” (six zeros). 000000
ºººººº
D10 D9 D8 D7 D6 D5
Clerks’ secret number Secret number
BBBB
D4 D3 D2 D1
To Next Page
Loading...
Need help?
General
