— 6 —
Setting up for Data Communications
The following procedures describe what you should do to set up for data communications
between two SF Units or between an SF Unit and a personal computer. In addition to
hardware connections, it details how to set up the communications parameters and how to
set up the SF-4300A / SF-4600 to receive data. By following these instructions carefully,
you can be ensured of successful communications every time.
To connect two SF Units
1. Check to make sure that the power of the two SF Units is switched off.
2. Remove the covers from the connectors on the two SF Units.
3. Connect the two SF Units using the optional SB-60/62 cable. You can also connect
them using an SB-60/62 cable.
Important
Be sure to replace the connector covers on the SF Units when you are not performing data
communications.
4) Check the hardware parameters.
1 While an initial screen is displayed, press FUNC twice to display the second function
menu.
• You can perform the above operation while the initial screen of the Telephone
Directory, Memo Mode, Schedule Keeper, Calendar, Reminder is displayed.
2 Press 4 to select DATA COMM.
3 Press 3 to select SET UP.
FUNC FUNC
2 ALL DELETE
3 LABEL EDIT
4 DATA COMM
CAPS
1 SEND
2 RECEIVE
3 SET UP
4 FDD
CAPS
SET UP
PARITY E O N
BIT LENGTH 7 8
BPS 2400 4800
CAPS
3
4
To Next Page
Loading...
Need help?
General
