E-26
Connecting the Power Supply and Various Devices
Setting the Stand and the Display
1. Loosen and remove the screw for the
cable fastener at the bottom of the
opening of the stand with a Phillips
screwdriver.
2. Route the connected cables into
the stand, passing them through the
opening. Remove the cutouts at the 4
locations in the stand base with pliers
and pull the cables through.
+
Do not insert ngers into the cutout. This may result in injury.
3. Hook the display onto the tab on the
stand and adjust the routed cables so
they will not sag too much or be too
tight. Arrange the cables so they will
not overlap, and fasten with the cable
fastener and secure with a screw.
Hook
To Next Page
Loading...
Need help?
General
