21
Starting Projection with Viewer
If the Data Projector is already turned on when you perform the procedure under “Connecting a
Memory Device to the Data Projector” (page 19) to connect USB memory to the Data Projector, the
main Viewer window shown below will be projected.
Note
If Viewer projection does not start automatically at this time, perform the following steps to
select “USB” as the input source.
1.
Press the [INPUT] key.
z This displays the input source selection screen.
2.
Use the [S] and [T] keys to move the highlighting to “USB” and then press the
[ENTER] key.
Menu Item Function Refer to:
Presentation Enters the Presentation Mode for
projection of ECA or PtG files.
“Projecting an ECA File or PtG File” (page 23)
“Converting a PowerPoint File to an ECA File or PtG
File” (page 14)
Slides Enters the Slide Mode for projection of
images files.
“Projecting an Image File” (page 26)
Movie Enters the Movie Mode for projection
of movie files.
“Projecting a Movie File” (page 28)
Viewer Setup Displays the Viewer setup menu. “Configuring Viewer Settings” (page 34)
To Next Page
Loading...
Need help?
General
