23
Projecting an ECA File or PtG File
Use the Viewer Presentation Mode to project ECA or PtG files.
To project an ECA file or PtG file
1.
Connect the memory device where the ECA file or PtG file you want to project is
stored to the Data Projector.
z This will project the main Viewer window. If the main Viewer window does not appear, press
the [INPUT] key and select “USB” as the input source.
2.
Use the cursor keys to move the highlighting to “Presentation” and then press
the [ENTER] key.
z This will project a file menu like the one shown below.
z If the ECA file or PtG file you want to play back is located in a particular folder, use the cursor
keys to move the highlighting to that folder and then press the [ENTER] key.
3.
Use the cursor keys to move the highlighting to the ECA file or PtG file you want
to play back and then press the [ENTER] key (or the [O] key).
z This will start playback of the selected ECA file or PtG file.
4.
Perform page change and other operations as required.
z For details about operations you can perform during projection of an ECA file or PtG file, see
“Operations during ECA File or PtG File Projection” (page 24).
z To stop ECA file or PtG file playback and return to the file menu, press the [ESC] key.
To Next Page
Loading...
Need help?
General
