7
Connecting a USB Device to the Data Projector
What happens when you connect a USB device while the Data Projector is turned on depends on the
current configuration of the Data Projector’s plug-and-play setting. Plug-and-play is enabled under
the Data Projector’s initial default settings. For more details about the plug-and-play setting, see
“Setup Menu Contents” in the User’s Guide.
If you connect a USB device to the Data Projector’s USB port while it is turned on, it will perform one
of the following operations (depending on its current plug-and-play setting).
When plug-and-play is enabled:
When plug-and-play is disabled:
In this case, the image that is currently being projected does not change. However, Viewer, or the YC
Camera Application will start up in the background, depending upon the type of USB device that is
connected to the Data Projector.
When this type of device is connected: The Data Projector does this automatically:
USB memory device or USB card reader
with memory card loaded
Starts up Viewer (page 19) and projects the Viewer screen.
YC-400/YC-430 Document Camera Starts up the YC Camera application (page 41) when the Document
Camera is turned on and projects the YC Camera application screen.
To Next Page
Loading...
Need help?
General
