CDA WC140 User Manual

Failure Codes and Troubleshooting
Your dishwasher control panel is equipped with a diagnostic display to help in the event of a problem with the appliance.
Error Code
Error description Advice
Intensive Normal Eco Quick Prewash
Inadequate water
supply
Make sure the water inlet tap is
fully open
Close the water tap, separate the
water inlet hose from the tap and
clean the filter
Restart your machine, contact
CDA service if the error resumes
Continual fill error
Close the tap and contact
CDA service
The waste water in
the machine cannot
be discharged.
Drain hose is blocked
The filters of your machine
might be blocked
Restart the dishwasher and
cancel the programme
If the error continues, contact
CDA service
Heater error Contact CDA service
Alarm is active against
water overflow
Turn off the dishwasher and
disconnect the water supply
Contact CDA service
Faulty electronic card Contact CDA service
Overheating error
(temperature in the
machine is too high)
Contact CDA service
Faulty heater sensor Contact CDA service

CDA WC140 Specifications

General

Door color	Not applicable
Display type	LED
Appliance placement	Fully built-in
Control panel color	Stainless steel
Drying class	B
Washing class	A
Noise level	52 dB
Number of place settings	12 place settings
Number of washing programs	5
Water consumption per cycle	15 L
Energy consumption per cycle	1.05 kWh

Weight and Dimensions

Depth	570 mm
Width	596 mm
Height	875 mm