CDA WC140 User Manual

Installation
• Do not install this appliance if it is damaged in any way. Installing a
damaged appliance may invalidate the warranty.
• The water supply tap should be located in an adjacent cupboard so that it
can be accessed after installation.
• Ensure the appliance is level by adjusting the feet as necessary.
• Only use the water inlet supplied with the appliance.
• If the water pressure is above 10 bar, a pressure relief valve should be used.
• After connecting the water supply, check to ensure there are no leaks.
• The water outlet can either be connected to a water drain or to a sink outlet
spigot. This connection should be at a minimum of 50 cm and a maximum
of 110 cm from the oor. The drain hose should be no longer than 4m in
length to ensure good performance from the dishwasher.
fig 14
fig 15
fig 16

CDA WC140 Specifications

General

Door color	Not applicable
Display type	LED
Appliance placement	Fully built-in
Control panel color	Stainless steel
Drying class	B
Washing class	A
Noise level	52 dB
Number of place settings	12 place settings
Number of washing programs	5
Water consumption per cycle	15 L
Energy consumption per cycle	1.05 kWh

Weight and Dimensions

Depth	570 mm
Width	596 mm
Height	875 mm