20
Installation
• Do not install this appliance if it is damaged in any way. Installing
a damaged appliance may invalidate the warranty.
• The water supply tap should be located in an adjacent cupboard
so that it can be accessed after installation.
• Ensure the appliance is level by adjusting the feet as necessary.
The dishwasher is equipped with an adjustable rear foot that can
be raised or lowered by means of an adjustment screw, located
in the centre of the kick plate.
• Only use the water inlet supplied with the appliance.
• If the water pressure is above 10 bar, a pressure relief valve
should be used.
• After connecting the water supply, check to ensure there are no
leaks.
• The water outlet can either be connected to a water drain or
to a sink outlet spigot. This connection should be at a minimum
of 50 cm and a maximum of 110 cm from the floor. The drain
hose should be no longer than 4m in length to ensure good
performance from the dishwasher.
• To prevent siphoning, ensure that the water outlet is not pushed
too far into the waste standpipe. The lowest part of the water
outlet should be level with the bottom basket of the dishwasher.
• When connecting to the sink, ensure that the waste pipe runs
higher than the level of the sink bowl to prevent siphoning.
• This appliance is cold fill only.
fig. 20
fig. 18
fig. 19
To Next Page
Loading...
Need help?
General
