21
fig. 21
Fitting the integrated appliance door
Where non-standard integrated appliance doors are supplied,
additional fitting instructions are required to ensure compatibility
with this product.
The machine is supplied with a fitting template and these
instructions should be followed as normal.
However, the fitting template needs to be located lower down the
fascia door; this is shown below.
The amount of oset, Y, depends on the height of the fascia door
and can be calculated as X = 723mm.
For example, if you have a 731mm tall fascia door and are fitting a
door to your dishwasher, then Y = 731-723 = 8mm.
Ensure that the hinge tensioners are adjusted to balance the weight
of the door.
Fitting template
Y oset
X Door height
To Next Page
Loading...
Need help?
General
