6
Control Panel
Cancelling a programme
It is possible to cancel the programme once is has started.
• First open the door slightly to reduce the risk of water spillage.
• Press and hold in the Programme Selection button until the end of programme indicator flashes and a “1” shows on
the display.
• Then close the door. The dishwasher will run a drain cycle which will take approximately 30 seconds. Once this is
complete, the dishwasher will beep five times and the end of programme light will switch on.
Switching the dishwasher o
• Once the dishwasher beeps five times and the end of programme light switches on, the dishwasher can be switched
o by pressing the Power button.
• Then turn o the water tap and remove the plug from the power socket.
Please note: the dishwasher will automatically continue on the programme it has started if the door is opened or
in the event of a power cut.
To Next Page
Loading...
Need help?
General
