Challenge Xtreme CX-TS 800 User Manual

Helpline No 0844 801 8701 / IRE 189 094 6244
10
4. Important notes
Please read this manual carefully and pay attention
to the information provided. Use this manual to
familiarize yourself with the machine, its correct use
and safety regulations.
The corresponding safety information can also be
found in this instruction manual.
Sound and vibration
Sound and vibration values were measured in
accordance with EN 61029.
Idling
LpA sound pressure level 95 dB(A)
KpA uncertainty 3 dB
LWA sound power level 108 dB(A)
KWA uncertainty 3 dB
Wear ear-muffs / ear defenders.
The impact of noise can cause damage to hearing.
“The quoted values are emission values and not
necessarily reliable workplace values. Although there
is a correlation between emission and immission
levels it is impossible to draw any certain conclusions
as to the need for additional precautions. Factors
with a potential influence on the actual immission
level at the workplace include the duration of impact,
the type of room, and other sources of noise etc.,
e.g. the number of machines and other neighboring
operations. Reliable workplace values may also vary
from country to country. With this information the user
should at least be able to make a better assessment
of the dangers and risks involved.”
Keep the noise emissions and vibrations to a
minimum.
• Onlyuseapplianceswhichareinperfectworking
order.
• Serviceandcleantheapplianceregularly.
• Adaptyourworkingstyletosuittheappliance.
• Donotoverloadtheappliance.
• Havetheapplianceservicedwhenevernecessary.
• Switchtheapplianceoffwhenitisnotinuse.
5. Technical data
Supply Voltage: 230 V ~ 50 Hz
Power rating: 800 W S2 10 min
Idle speed n0: 2950 rpm
Carbide saw blade: 200 x 16 x 2.4 mm
Number of teeth: 20
Table size: 500 x 335 mm
Cutting height max. 90°: 43 mm
Cutting height max. 45°: 35 mm
Connector for dust extractor: dia. 35 mm
Size, complete: 500 x 335 x 370 mm
Weight: 13,1 kg
Load factor:
A load factor of S2 10 min (intermittent periodic duty)
means that you may operate the motor continuously
at its nominal power level (800 W) for no longer than
the time stipulated on the specifications label (10
minutesONperiod).Ifyoufailtoobservethistime
limitthemotorwilloverheat.DuringtheOFFperiod
the motor will cool again to its starting temperature.
6. Before starting the equipment
• Themachinehastobesetupwhereitcanstand
firmly, e.g. on a work bench, or it must be bolted to
a strong stand.
• Allthecoversandsafetydeviceshavetobe
properly fitted before the machine is switched on.
• Itmustbepossibleforthesawbladetorunfreely.
• Whenworkingwithwoodthathasbeenprocessed
before, watch out for foreign bodies such as nails
or screws etc.
• BeforeyouactuatetheOn/Offswitch,makesure
that the saw blade is correctly fitted and that the
machine’s moving parts run smoothly.
• Beforeyouconnectthemachinetothepower
supply, make sure the data on the rating plate is
the same as that for your mains.

Challenge Xtreme CX-TS 800 Specifications

General

Brand	Challenge Xtreme
Model	CX-TS 800
Category	Saw
Language	English