Finding
a
Station
Setting the Tone
AM.FM:
Press
this
button to switch between
AM
and
FM.
The display shows your selection.
TUNE:
Press the right or
left
arrows
to go to a higher or
lower station. Press and hold to continue tuning and
release when you find your station. The display will
show the frequency of each station tuned.
SEEK:
Press the right or left arrow to go to the next
higher or lower station and stay there.
PUSHBUTTONS:
The six numbered pushbuttons let
you return to your previously played stations. You can
set
up
to 12 stations (six
AM
and six
FM).
Just:
1.
Turn the radio on.
2. Press
AM.FM
to select the band.
3.
Tune
in
the desired station.
4.
Press and hold one of the
six
pushbuttons for at least
two seconds. The sound will mute and then return
when the station
is
stored. Whenever you press that
numbered button, the station you set will return.
5.
Repeat the steps for each pushbutton.
BASS:
Press this knob lightly
so
it extends. Turn the
knob to the right to increase bass and to the left to
decrease bass.
TREB:
Press
this
knob lightly
so
it
extends.
Turn
the
knob to the right to increase treble and to the left to
decrease treble.
If
a station is weak
or
noisy, you may
want to decrease the treble.
hsh these knobs back into their stored positions when
you’re not using them.
Adjusting the Speakers
BAL:
Press
this
knob lightly so it extends. Then pull the
knob
all
the way out.
Turn
the knob to the right for the
right speakers and to the left for the left speakers. The
middle position balances the sound between the speakers.
FADE:
Press this knob lightly
so
it extends. Then pull
the knob all the way out. Turn the knob to the right to
adjust the sound to the rear speakers and to the left
for
the fi-ont speakers. The middle position balances the
sound between the speakers.
Push these knobs back into their stored positions when
you’re not using them.
3-7
To Next Page
Loading...
Need help?
General
