Part
C:
Periodic
Maintenance Inspections
Listed below are inspections and services which should
be performed at least twice a year (for instance, each
spring and fall).
You
should let your dealer’s service
department or other qualified service center do these
jobs. Make sure any necessary repairs are completed
at once.
7xhaust Syste:--
p-
1sy::A’on
inspect the complete exhaust system. Inspect the body
near the exhaust system. Look for broken, damaged,
missing or out-of-position parts as well as open seams,
holes, loose connections or other conditions which
could cause a heat build-up in the floor pan or could
let exhaust fumes into the vehicle. See “Engine
Exhaust” in the Index.
Proper procedures to perform these services may be
found in a service manual. See “Service and Owner
Publications” in the Index.
Steering, Suspension and Front Drive
Axle Boot and Seal Inspection
Inspect the front and rear suspension and steering
system for damaged, loose or missing
parts,
signs
of
wear
or
lack
of
lubrication. Inspect the power steering
lines and hoses for proper hook-up, binding, leaks,
cracks, chafing, etc. Clean and then inspect
the
drive
axle boot seals for damage, tears or leakage. Replace
seals if necessary.
Engine Cooling System Inspection
Inspect the hoses and have them replaced if they are
cracked, swollen or deteriorated. Inspect all pipes, fittings
and clamps; replace as needed. Clean the outside
of
the
radiator and air conditioning condenser.
To
help ensure
proper operation, a pressure test of the cooling system
and pressure cap is recommended at least once a year.
7-5
1
To Next Page
Loading...
Need help?
General
