yellowblue
6-38
Dome Lamp
1. Grasp the front and rear center of the dome
lamp cover at the same time. Then squeeze
and pull downward. (To help pry the sides loose,
a screwdriver may be used as an aid during
this procedure.)
2. Remove the old bulb from the small prongs
extending from the dome lamp base plate; hook the
new bulb onto the prongs.
3. To replace the bulb cover, center it over the base
plate, making sure both the cover and the base plate
line up properly. Snap the cover firmly into place.
For any bulb changing procedure not listed in
this section, contact your Chevrolet dealer
service department.
Windshield Wiper
Blade Replacement
1. Turn on the wipers to the low wipe setting.
To Next Page
Loading...
Need help?
General
