7-5
Scheduled Maintenance
The services shown in this schedule up to 100,000 miles
(166 000 km) should be performed after 100,000 miles
(166 000 km) at the same intervals. The services shown
after 100,000 miles (166 000 km) should be performed
at those same intervals.
This vehicle has a computer that lets you know when to
change your engine oil. This is not based on mileage,
but on engine revolutions and engine operating
temperature. When the computer has calculated that
the oil needs changing, the Oil Life Monitor will
indicate that a change is necessary.
The “Footnotes” at the end of this Maintenance
Schedule further explain maintenance services.
If the vehicle has a Caterpillar
R
diesel engine,
see the Caterpillar
R
Diesel Engine Operation &
Maintenance Manual for supplemental engine
maintenance information.
100 Miles (160 km)
j
Wheel stud nut service. (45)
500 Miles (800 km)
j
Wheel stud nut service. (45)
1,000 Miles (1 600 km)
j
Wheel stud nut service. (45)(46)
3,000 Miles (5 000 km)
j
Check Oil Life Monitor. If engine oil and filter
are changed, reset monitor. See “Engine Oil”
in the Index. (3)(9)
j
Check fluid levels (or every 3 months, whichever
occurs first). (1)(2)(6)
j
Clutch pedal free travel service. (10)
j
Rear axle air shift motor service. (11)
To Next Page
Loading...
Need help?
General
