Radio with CD (MP3)
Playing the Radio
ON/OFF: Press this knob to turn the system on and off.
VOL (Volume): Turn this knob to increase or to
decrease the volume.
Finding a Station
AM/FM: Press this button to switch between FM1, FM2,
or AM. The display will show the selection.
TUN (Tune): Turn this knob to select radio stations.
SCAN: Push and release this knob to scan radio
stations. The radio will go to a station, play for a few
seconds, then go on to the next station. Push this knob
again to stop scanning.
The radio will only scan stations with a strong signal
that are in the selected band.
Setting Preset Stations
Up to 18 stations (six FM1, six FM2, and six AM), can
be programmed on the six numbered pushbuttons,
by performing the following steps:
1. Turn the radio on.
2. Press AM/FM to select FM1, FM2, or AM.
3. Tune in the desired station.
4. Press and hold one of the six numbered
pushbuttons for longer than two seconds. The
pushbutton number will flash on the display when
the station has been set. Whenever that numbered
pushbutton is pressed, the station that was set
will return.
5. Repeat the steps for each pushbutton.
3-41
To Next Page
Loading...
Need help?
General
