In order to access the top strap anchor, remove the
anchor’s plastic cover by squeezing and pulling the front
part of the cover in the direction shown by the arrow.
The plastic cover should remain off while the top
strap anchor is in use.
Anchor the top strap to an anchor point specified in
Top Strap Anchor Location on page 1-39. Be sure to
use an anchor point located on the same side of
the vehicle as the seating position where the child
restraint will be placed.
{CAUTION:
Each top tether bracket is designed to anchor
only one child restraint. Attaching more than
one child restraint to a single bracket could
cause the anchor to come loose or even break
during a crash. A child or others could be
injured if this happens. To help prevent injury
to people and damage to your vehicle, attach
only one child restraint per bracket.
Once you have the top strap anchored, you will be
ready to secure the child restraint itself. Tighten the top
strap when and as the child restraint manufacturer’s
instructions say.
Top Strap Anchor Location
Top strap anchors are already installed in your vehicle
for the rear seating positions.
Do not secure a child restraint in the right front
passenger’s position if a national or local law requires
that the top strap be anchored, or if the instructions
that come with the child restraint say that the top strap
must be anchored. There is no place to anchor the
top strap in this position.
You will find the three anchors on your sedan behind
the rear seat on the filler panel.
Sedan
1-39
To Next Page
Loading...
Need help?
General
