Cruise Control
With cruise control, a speed of about 25 mph (40 km/h)
or more can be maintained without keeping your foot
on the accelerator. Cruise control does not work
at speeds below about 25 mph (40 km/h).
Cruise control will not work if the parking brake is set, or
if the master cylinder brake fluid level is low.
If the brakes are applied, the cruise control shuts off.
{ CAUTION:
Cruise control can be dangerous where you
cannot drive safely at a steady speed. So, do not
use the cruise control on winding roads or in
heavy traffic.
Cruise control can be dangerous on slippery roads.
On such roads, fast changes in tire traction can
cause excessive wheel slip, and you could lose
control. Do not use cruise control on slippery roads.
If the vehicle’s StabiliTrak
®
/Traction Control System
(TCS) begins to limit wheel spin while the cruise control
is on, the cruise control automatically disengages.
See StabiliTrak
®
System on page 4-6 or Traction Control
System (TCS) on page 4-8. When road conditions allow
you to safely use it again, the cruise control can be
turned back on.
These controls are located at the end of the multifunction
lever.
9 (Off): Turns the system off.
R (On): Turns the system on.
+ (Resume/Accelerate): Use to make the vehicle
accelerate or resume a previously set speed.
rT(Set): Press the button at the end of the lever to
set the speed.
3-10
To Next Page
Loading...
Need help?
General
