Sunroof
On vehicles with this
feature, the switch is
located on the headliner
between the sun visors.
The sunroof only operates when the ignition is turned to
ON/RUN. The sunroof can be opened to a vent position
or it can be opened all of the way.
To open the sunroof to the vent position, open the
sunshade. Then press and hold the driver side of the
switch. To close the sunroof, press and hold the
passenger side of the switch until the sunroof reaches
the desired position.
To fully open the sunroof, press and hold the passenger
side of the switch. The sunshade opens with the
sunroof. To close the sunroof, press and hold the driver
side of the switch. The sunroof will stop if the switch is
released during operation. Close the sunshade
manually.
In both the vent and fully open positions, the air flow
can be adjusted by pushing and holding the switch until
the sunroof moves to the desired position.
The sunroof cannot be opened or closed if the vehicle
has an electrical failure.
Dirt and debris may collect on the sunroof seal or in the
tracks that could cause an issue with sunroof operation,
noise or plug the water frainage system. Periodically
open the sunroof and remove any obstacles or loose
debris. Wipe the sunroof seal and roof sealing area
using a clean cloth, mild soap, and water. Do not
remove grease from sunroof.
3-37
To Next Page
Loading...
Need help?
General
