Vehicle Care 10-29
Fog Lamps
To replace the front fog lamp bulb:
1. Remove the five access panel
fasteners under the front fascia.
2. Lower the panel far enough to
access the fog lamp bulb.
3. Remove the bulb by turning it
counterclockwise and pulling it
straight out of the assembly.
4. Disconnect the electrical
connector from the fog lamp bulb
assembly.
5. Install the new bulb by turning it
clockwise into the assembly.
6. Reverse Steps 1–4 to reinstall.
Taillamps, Turn Signal,
Stoplamps, and Back-Up
Lamps (LS and LT)
1. Back-Up Lamp
2. Taillamp
Trunk Deck Inboard Taillamp and
Back-Up Lamp
1. Open the trunk. See Trunk on
page 2-14.
2. Remove the push pins and pull
back the trunk deck trim.