VIII. LONG TERM STORAGE INSTRUCTIONS: (Storage exceeding 30 days after receipt of equipment)
NOTE: Failure to adhere to these instructions voids all warranties in their entirety.
1. Storage site selection:
a. Level, well-drained, firm surface, in clean, dry and warm location. Minimum temperature of 50°F (10°C).
b. Isolated from possibility of physical damage from construction vehicles, erection equipment, etc.
c. Accessible for periodical inspection and maintenance.
2. The blower should be supported under each corner of its base to allow it to “breath”. Supports (2 x 4’s, timbers, or
railroad ties) should be placed diagonally under each corner.
3. If the equipment is to be stored for more than three (3) months, the entire blower assembly must be loosely covered
with plastic, but not tightly wrapped.
4. Storage Maintenance:
A periodic inspection and maintenance log, by date and action taken, must be developed and main-
tained for each blower. See example below. Each item must be checked monthly.
EXAMPLE:
Storage / Maintenance Schedule Log
OMM-23-1009-page 12
Long Term Storage instructions continued on page 13.
To Next Page
Loading...
Need help?
General
