DANGER
OMM-23-1009-page 2
TABLE OF CONTENTS
Hazardous voltage High speed rotating Lock out/Tag out to Avoid injury. NEVER Avoid injury. You MUST
c
an cause electrical equipment can cause prevent personal injury operate without ALL
r
ead and understand all
shock and death. severe personal injury. BEFORE
starting ANY required safety instructions in this manual
service or inspection. guards in place. BEFORE
installing.
I. GENERAL
A. Unpacking and Handling .............................2
B. Safety Accessories & Instructions............2-3
II. INSTALLATION
A. Vibration.......................................................3
B. Mounting Methods....................................3-4
C. Duct Work Connections...............................4
D. Safety Guards..............................................4
E. Dampers and Valves....................................4
F. Set Screw & Taper-lock Bushing
Torque Values ..............................................5
III. ELECTRICAL
A. Disconnect Switches ...................................5
B. Motors.......................................................5-6
C. Maximum Blower Speed..............................6
IV. INITIAL UNIT STARTUP
A. Pre-Startup & Post-Startup Checks.............7
B. Vibration....................................................8-9
V. ROUTINE INSPECTION & MAINTENANCE .....9
A. Hardware ...................................................10
B. Motor Bearing Lubrication .........................10
C. Wheel Balance ..........................................10
D. Vibration.....................................................10
E. Dampers and Valves..................................10
F. Safety Equipment or Accessories .........10-11
VI. ORDERING PARTS .........................................11
VII. TROUBLESHOOTING ................................11-12
VIII. LONG TERM STORAGE ............................12-13
IX. WARRANTY, LIABILITY & RETURNS............14
X. PARTS DRAWING ...........................................15
I. GENERAL
A. Unpacking:
Be careful not to damage or deform any parts of the blower when removing it from the packaging container. All the
packaging material should be kept in the event the blower needs to be returned.
Handling:
Handling of the blower should be performed by trained personnel and be consistent with all safe handling practices.
Verify that all lifting equipment is in good operating condition and has the proper lifting capacity. The blower should
be lifted using well-padded chains, cables or lifting straps with spreader bars. Some blower models have lifting eye
locations provided in the blower base. NEVER lift the blower by an inlet or discharge flange, motor shaft,
motor eye bolt, or any other part of the blower assembly that could cause distortion of the blower
assembly.
B. Safety Instructions & Accessories:
1. Safety Instructions:
All installers, operators and maintenance personnel should read AMCA Publication 410-96, “Recommended Safety
Practices for Users and Installers of Industrial and Commercial Fans”. This manual is included with the blower.
Additional copies can be requested by writing us at Cincinnati Fan, 7697 Snider Rd., Mason, OH 45040-9135
2. Sound:
Some blowers can generate sound that could be hazardous to personnel. It is the responsibility of the user to measure
the sound levels of the blower and/or system, determine the degree of personnel exposure, and comply with all appli-
cable safety laws and requirements to protect personnel from excessive noise.
To Next Page
Loading...
Need help?
General
