Cisco 3800 Series User Manual

69
Installing SFP Modules in Cisco 3800 Series Routers
OL-5968-01
Installing SFP Modules in
Cisco 3800 Series Routers
This document describes how to install optional small-form-factor pluggable (SFP) modules in
Cisco 3800 series integrated services routers to provide optical Gigabit Ethernet connectivity. It contains
the following sections:
• Installing SFP Modules, page 70
• Removing SFP Modules, page 71
The SFP module installs into a slot on the router’s rear panel. When selected in Cisco IOS software, it
is assigned port gigabitethernet 0/0. The default is for the built-in RJ-45 1000Base-T connector to be
active on this port.
Only SFP modules certified by Cisco are supported on Cisco 3800 series routers. Table 6 lists supported
SFPs.
Tip Use the show controller command at the Cisco IOS prompt to determine whether you are using an SFP
certified by Cisco.
Table 6 SFPs Supported on Cisco 3800 Series Routers
Cisco Part Number SFP Transceiver
Fiber Diameter
(micrometer)
Wavelength
(nm) Mode
Maximum
Distance
GLC-SX-MM= 1000Base-SX 50 850 Multi 550 m
GLC-LH-SM= 1000Base-LX/LH 9/125 1310 Single 10 km
GLC-ZX-SM= 1000Base-ZX 9/125 1550 Single 100 km
CWDM-SFP-1470= 1000Base-CWDM 50 1470 Single 100 km
CWDM-SFP-1490= 1490
CWDM-SFP-1510= 1510
CWDM-SFP-1530= 1530
CWDM-SFP-1550= 1550
CWDM-SFP-1570= 1570
CWDM-SFP-1590= 1590
CWDM-SFP-1610= 1610

Cisco 3800 Series Specifications

General

Brand	Cisco
Model	3800 Series
Category	Network Router
Language	English