Cisco 3800 Series User Manual

93
Installing and Upgrading Internal Components in Cisco 3800 Series Routers
OL-5975-04
AIM Installation and Removal
Verifying AIM Installation
Use the show diag 0 command to obtain hardware information about an installed AIM. The following
example shows the hardware revision and additional information about ATM AIM 0:
Router# show diag 0
.
.
.
ATM AIM 0:
Applying the AIM Label
The AIM is supplied with a two-part adhesive label in the mounting kit or attached to the AIM card. Use
one part of the label to identify the AIM on the motherboard, and apply the other part to the outside of
the router. Apply the labels as follows:
Step 1 If the label is attached to the AIM card, carefully tear off the label at the perforation. If the label is in
the mounting kit, separate the two parts at the perforation, and apply one part to the AIM card.
Step 2 Position the other part of the label in a blank area on the rear panel of the router, near an edge. If no
suitable space is available on the rear panel, apply the label to the cover at the rear edge.
Note Do not apply the AIM label to a blank cover plate; to any removable network module or interface
card; or over any holes, screws, or existing labels.

Cisco 3800 Series Specifications

General

Brand	Cisco
Model	3800 Series
Category	Network Router
Language	English