Cisco 7246VXR - uBR Router User Manual

1-94
Cisco uBR7200 Series Universal Broadband Router Software Configuration Guide
OL-2239-05
Chapter 1 Overview of Cisco uBR7200 Series Software
cops tcp window-size
Command History
Usage Guidelines The pre-equalization exclusion feature should be configured for the running configuration of the
Network Processing Engine (NPE), the Performance Routing Engine (PRE), and the line card console.
Examples The following example configures pre-equalization to be excluded for the specified cable modem.
Pre-equalization data is not sent for the corresponding cable modem:
Router(config)# cable pre-equalization exclude modem mac-addr
The following example configures pre-equalization to be excluded for the specified OUI value of the
entire interface. Pre-equalization data is not sent for the corresponding OUI value of the entire interface:
Router(config)# cable pre-equalization exclude oui mac-addr
The following series of commands configures pre-equalization on the Cisco uBR7246VXR router with
MC5X20U BPEs. On the PRE Console, configure the following commands.
Router# conf t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# cable pre-equalization exclude oui 00.09.04
Router(config)# end
Router# show run
Router# show running-config | inc oui
cable pre-equalization exclude oui 00.09.04
Router#
On the line card console for the same Cisco uBR7246VXR router, verify the configuration with the
following command:
clc_7_1# show running-config | inc oui
cable pre-equalization exclude oui 00.09.04
clc_7_1#
The following series of commands configures pre-equalization on the Cisco uBR7246VXR router with
MC28U cable interface line cards. On the Network Processing Engine (NPE) console, configure and
verify with the following commands.
npeg1-test# conf t
Enter configuration commands, one per line. End with CNTL/Z.
npeg1-test(config)# cable pre-equalization exclude oui 00.09.24
npeg1-test(config)# end
npeg1-test#show ru
02:58:10: %SYS-5-CONFIG_I: Configured from console by consolen
npeg1-test# show running-config | inc oui
cable pre-equalization exclude oui 00.09.24
npeg1-test#
On the line card console for the same Cisco uBR7246VXR router, verify the configuration with the
following command:
clc_4_0# show running-config | inc oui
cable pre-equalization exclude oui 00.09.24
clc_4_0#
Release Modification
12.3(17a)BC This command was introduced to the Cisco uBR10012 router and the
Cisco
uBR7246VXR router.

Cisco 7246VXR - uBR Router Specifications

General

Brand	Cisco
Model	7246VXR - uBR Router
Category	Network Router
Language	English