Cisco 7246VXR - uBR Router User Manual

2-8
Cisco uBR7200 Series Universal Broadband Router Software Configuration Guide
OL-2239-03
Chapter 2 Configuring the Cable Modem Termination System for the First Time
Configuration Fundamentals for the Cisco uBR7200 Series
• If Break is enabled, the router enters the ROM monitor, indicated by the ROM monitor prompt
(
rommon n>), where n is the number of the command line. Proceed to Step 6.
• If Break is disabled, power cycle the router (turn the router off or unplug the power cord, and then
restore power). Proceed to
Step 5.
Step 5 Within 60 seconds of restoring the power to the router, press the Break key or send a Break. This action
causes the router to enter the ROM monitor and display the ROM monitor prompt (
rommon 1>).
Step 6 To set the configuration register on a Cisco uBR7200 series router, use the configuration register utility
by entering the confreg command at the ROM monitor prompt as follows:
rommon 1> confreg
Answer yes to the enable ignore system config info? prompt and note the current configuration
register settings.
Step 7 Initialize the router by entering the reset command as follows:
rommon 2> reset
The router initializes, the configuration register is set to 0x142, the router boots the system image from
Flash memory and enters the System Configuration dialog (setup), as follows:
--- System Configuration Dialog --
Step 8 Enter no in response to the System Configuration dialog prompts until the following message appears:
Press RETURN to get started!
Step 9 Press Return. The user EXEC prompt appears as follows:
Router>
Step 10 Enter the enable command to enter privileged EXEC mode.
Step 11 Enter the show startup-config command to display the passwords in the configuration file as follows:
Router# show startup-config
Step 12 Scan the configuration file display looking for the passwords; the enable passwords are usually near the
beginning of the file, and the console login or user EXEC password is near the end. The passwords
displayed will appear similar to the following:
enable secret 5 $1$ORPP$s9syZt4uKn3SnpuLDrhuei
enable password 23skiddoo
.
.
line con 0
password onramp
Note The enable secret password is encrypted and cannot be recovered; it must be replaced. The enable and
console passwords can be encrypted text or clear text.
Proceed to the next step to replace an enable secret, console login, or enable password. If there is no
enable secret password, note the enable and console login passwords if they are not encrypted and
proceed to
Step 17.

Cisco 7246VXR - uBR Router Specifications

General

Brand	Cisco
Model	7246VXR - uBR Router
Category	Network Router
Language	English