Cisco 7246VXR - uBR Router User Manual

2-24
Cisco uBR7200 Series Universal Broadband Router Software Configuration Guide
OL-2239-03
Chapter 2 Configuring the Cable Modem Termination System for the First Time
Configuring the Cisco uBR7200 Series Using the Setup Facility
The following configuration command script was created:
hostname Router
enable secret 5 $1$u8z3$PMYY8em./8sszhzk78p/Y0
enable password wilma
line vty 0 4
password s
snmp-server community public
!
ip routing
no vines routing
no ipx routing
no appletalk routing
no apollo routing
no decnet routing
no xns routing
no clns routing
no bridge 1
! Turn off IPX to prevent network conflicts.
interface Ethernet0/0
no ipx network
interface Ethernet0/1
no ipx network
!
interface Ethernet0/0
ip address 1.1.1.10 255.0.0.0
no mop enabled
!
interface serial0/0
ip address 1.1.1.20 255.0.0.0
ip route-cache cbus
no keepalive
!
!
router igrp 15
network 1.0.0.0
!
end
Use this configuration? [yes/no]: yes
[OK]
Use the enabled mode `configure' command to modify this configuration.
Press RETURN to get started!
Yo u r C i sc o uBR7200 series router is now minimally configured and is ready to use. Use the setup
command in provileged EXEC mode if you want to modify the parameters after the initial configuration.
To perform more complex configurations, use the configure privileged EXEC command in global
configuration mode.
Setup Facility Examples
In the following example, the upstream parameters for a cable interface line card in slot 5 are configured
and enabled. Press Return to accept the default.
Do you want to configure Cable 5/0 interface? [no]: yes
Downstream setting frequency: 531000000
For cable upstream [0]
Shut down this upstream? [yes/no]: no
Frequency: 33808000
Would you like to configure the DHCP server? [yes/no]: yes

Cisco 7246VXR - uBR Router Specifications

General

Brand	Cisco
Model	7246VXR - uBR Router
Category	Network Router
Language	English