Cisco 7910G User Manual

Joining a Meet-Me Conference
Cisco 7912 Telephone User Guide System Telephone Features 37
620-05600350
Dialing In Too Early
If you dial the Meet-Me Conferencing number more than five minutes prior to the
scheduled conference call time, you will hear the following message and the
system will then disconnect:
“Your conference is not scheduled to start until (time) on (day, date). Please
call back at that time.”
Entering an Incorrect ID
If you enter the wrong Guest or Moderator ID, the system informs you the
conference you wish to join could not be found and prompts you to press 1 to re-
enter the conference ID or press the * key to end the call.
If you pressed 1, do the following:
1. Enter the ID of the conference you wish to join.
2. Press the # key.
The conference
reservation state changes
from Active to Ends Soon.
You are the moderator and
only caller connected to the
conference.
You hear the Ends Soon
announcement.
Another participant joins
the conference.
You were listening to the
First Caller announcement
when silence was started.
You will be connected to
the conference.
You are the moderator. You perform any floor
control operation.
You will be prompted with
the appropriate
announcement and
connected to the
appropriate announcement
based on the conference
state.
The Start Soon
announcement was playing
when silence was started.
The moderator mutes or
unmutes you.
You will hear the Starts
Soon announcement.
The conference bridge
state changes for some
reason.
N/A You will hear the Starts
Soon, First Caller or Ends
Soon announcement
depending on the
conference reservation
state.
When... And if... Then

Cisco 7910G Specifications

General

Brand	Cisco
Model	7910G
Category	IP Phone
Language	English