Configuring Serial Interfaces on the Cisco ASR 9000 Series Router
How to Configure Serial Interfaces
533
Cisco ASR 9000 Aggregation Services Router Interfaces and Hardware Component Configuration Guide
OL-26061-03
What to Do Next
• To configure a point-to-point pseudowire XConnect on the AC you just created, see the
“Implementing Layer 2 Tunnel Protocol Version 3” module of the Cisco IOS XR Virtual Private
Network Configuration Guide for the Cisco CRS Router.
• To configure an L2VPN, see the “Implementing MPLS Layer 2 VPNs” module of the Cisco IOS XR
Virtual Private Network Configuration Guide for the Cisco CRS Router.
• To configure a point-to-point pseudowire XConnect on the AC you just created, see the
“Implementing Layer 2 Tunnel Protocol Version 3 on Cisco IOS XR Software” module of the Cisco
IOS XR Virtual Private Network Configuration Guide for the Cisco XR 12000 Series Router.
• To configure an L2VPN, see the “Implementing MPLS Layer 2 VPNs on Cisco IOS XR Software”
module of the Cisco IOS XR Virtual Private Network Configuration Guide for the Cisco XR 12000
Series Router.
Configuring IPHC
This section contains the following step procedures:
• Prerequisites for Configuring IPHC, page 533
• Configuring the IPHC Slot Level Command, page 534
• Configuring an IPHC Profile, page 536
• Configuring an IPHC Profile, page 538
• Enabling an IPHC Profile on an Interface, page 541
Prerequisites for Configuring IPHC
IP header compression (IPHC) is supported on the following cards:
• Cisco 1-Port Channelized OC-12/STM-4
Step 9
Repeat Step 1 through Step 7 to configure the PVC at
the other end of the AC.
Brings up the AC.
Note The configuration on both ends of the connection
must match.
Step 10
show policy-map interface serial
interface-path-id.subinterface {input | output}
or
show policy-map type qos interface serial
interface-path-id.subinterface {input | output}
Example:
RP/0/0RP0/CPU0:router# show policy-map
interface pos 0/1/0/0.1 output
or
RP/0/0RP0/CPU0:router# show policy-map type qos
interface pos 0/1/0/0.1 output
(Optional) Displays the statistics and the configurations of
the input and output policies that are attached to a
subinterface.
Command or Action Purpose
To Next Page
Loading...
Need help?
General
