Configuring Serial Interfaces on the Cisco ASR 9000 Series Router
Additional References
547
Cisco ASR 9000 Aggregation Services Router Interfaces and Hardware Component Configuration Guide
OL-26061-03
multilink group 4
commit
IPHC on a Serial Interface with MLPPP/LFI and QoS Configuration: Example
The following example shows how to configure IP header compression (IPHC) on a serial interface with
LFI and by specifying a QoS service policy that contains an IPHC profile:
config
interface multilink 0/4/3/0/4
ipv4 address 10.10.10.10
multilink
fragment-size 128
interleave
ipv4 iphc profile Profile_2 mode service-policy
service-policy output SP_2
commit
interface serial 0/1/0/1:2
encapsulation ppp
multilink group 4
commit
Additional References
The following sections provide references related to T3/E3 and T1/E1 controllers and serial interfaces.
Related Documents
Related Topic Document Title
Cisco IOS XR master command reference Cisco IOS XR Master Commands List
Cisco IOS XR interface configuration commands Cisco IOS XR Interface and Hardware Component Command
Reference
Initial system bootup and configuration information for
a router using Cisco IOS XR software
Cisco IOS XR Getting Started Guide
Cisco IOS XR AAA services configuration information Cisco IOS XR System Security Configuration Guide and
Cisco IOS XR System Security Command Reference
Information about configuring interfaces and other
components on the Cisco CRS-1 Router from a remote
Craft Works Interface (CWI) client management
application
Cisco Craft Works Interface Configuration Guide
To Next Page
Loading...
Need help?
General
