Cisco ASR 920 series Installing Guide

Installing the Cisco ASR 920 Series Router
This chapter describes how to install the Cisco ASR 920 Series Router and includes the following sections:
•
Prerequisites, page 1
•
Installing the Router in a Rack, page 2
•
Wall Mounting the Cisco ASR 920 Series Router, page 11
•
Install the AC Power Cables, page 14
•
Install the DC Power Supply, page 16
•
Install and Remove SFP Modules, page 19
•
Connect to the 10/100/1000 Ports, page 23
•
Install the Chassis Ground Connection, page 25
•
Power Connection Guidelines, page 28
•
Connect the Chassis to the Network, page 31
Prerequisites
Before installing the Cisco ASR 920 Series Router, it is important to prepare for the installation by:
•
Preparing the site (site planning) and reviewing the installation plans or method of procedures (MOP).
See “Site Planning” section on page 2-9 .
• Unpacking and inspecting the Cisco ASR 920 Series Router. See “Receiving the Cisco ASR 920 Series
Router” section on page 2-20 .
•
Gathering the tools and test equipment required to properly install the Cisco ASR 920 Series Router.
See “Tools and Equipment” section on page 2-21 .
For more instructions on how to prepare for the installation of the Cisco ASR 920 Series Router, see Chapter
2, “Preparing for Installation.”
Cisco ASR 920 Series Aggregation Services Router Hardware Installation Guide
1

Cisco ASR 920 series Specifications

General

Brand	Cisco
Model	ASR 920 series
Category	Network Router
Language	English