Cisco ASR 920 series Installing Guide

Installing the Router in a Rack
The following sections describe how to install the Cisco ASR 920 Series Router in a rack. The procedures in
this section apply to both horizontal and vertical mounting of the router in a rack:
Installing the Chassis Brackets
The chassis is shipped with mounting brackets that can be installed on the front or rear of the chassis. To
install the brackets on the front of the chassis, perform these steps:
SUMMARY STEPS
1.
Remove the rack-mount brackets from the accessory kit and position them beside the router chassis.
2.
Position one of the brackets against the chassis side, and align the screw holes.
3.
Secure the bracket to the chassis with the screws removed when performing Step 1 . The recommended
maximum torque is 10 in.-lb.
4.
Repeat Step 2 and Step 3 for the other bracket.
DETAILED STEPS
Step 1
Remove the rack-mount brackets from the accessory kit and position them beside the router chassis.
The figure below shows how to attach the brackets at the front, middle, and rear positions on the Cisco ASR 920 Series
Router for a 19-inch EIA rack.
Figure 1: Attaching Mounting Brackets for a 19-inch EIA Rack (Front, Middle, and Rear Positions)
Cisco ASR 920 Series Aggregation Services Router Hardware Installation Guide
2
Installing the Cisco ASR 920 Series Router
Installing the Router in a Rack

Cisco ASR 920 series Specifications

General

Brand	Cisco
Model	ASR 920 series
Category	Network Router
Language	English