Cisco Catalyst 1900 Series Quick Start Guide

5
4 Display the Web Console
After you assign an IP address to the switch, you can display the web console.
1 Start Netscape Communicator 4.xx or Internet Explorer 4.xx.
If you use Netscape 4.xx, enable JavaScript in the Advanced Preferences list. If you use
Explorer 4.xx, JavaScript is enabled by default.
2 Enter the IP address of the switch in the Location field if you are using Netscape (the
Address field if you are using Internet Explorer), and press Return. The Basic System
Configuration page appears.
The switch is designed to operate with little or no user intervention. In most cases, you can use
it with its default settings as soon as you assign it an IP address. You can also use the web
console to change the switch configuration and monitor network conditions and statistics.
Note: The Catalyst 1900 Series Installation and Configuration Guide provides complete
information about the web console and describes how to configure the switch.
Click Apply after
making changes
on a page.
Click Revert
to discard
"unapplied"
changes on
a page.
Click Help
for help on a
specific page.
Click the Mode button
to change the mode
the LEDs display: port
status, switch utilization,
and port duplex operation.
Click these topics to move
from page to page. When the
cursor is above a topic, a
pop-up briefly describes the
options on that particular page.
(On Netscape only.)
Click a port to display
its settings and statistics.

Cisco Catalyst 1900 Series Specifications

General

Brand	Cisco
Model	Catalyst 1900 Series
Category	Switch
Language	English