EasyManuals Logo
Home>Cisco>Wireless Access Point>Catalyst 9136I Series

Cisco Catalyst 9136I Series User Manual

Cisco Catalyst 9136I Series
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #40 background imageLoading...
Page #40 background image
2. This device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a residential environment. This equipment generates, uses,
and radiates radio frequency energy, and if not installed and used in accordance with the instructions, may
cause harmful interference. However, there is no guarantee that interference will not occur. If this equipment
does cause interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna
Increase separation between the equipment and receiver
Connect the equipment to an outlet on a circuit different from which the receiver is connected
Consult the dealer or an experienced radio/TV technician
Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate this equipment.This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation.This
device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or
transmitter. For product available in the USA/Canada market, only channel 1~11 can be operated. Selection
of other channels is not possible.FCC regulations restrict the operation of this device to indoor use only. The
operation of this device is prohibited on oil platforms, cars, trains, boats, and aircraft, except that operation
of this device is permitted in large aircraft while flying above 10,000 feet.Operation of transmitters in the
5.925-7.125 GHz band is prohibited for control of or communications with unmanned aircraft systems.
Caution
VCCI Statement for Japan
This is a Class B product based on the standard of the Voluntary Control
Council for Interference from Information Technology Equipment
(VCCI). If this is used near a radio or television receiver in a domestic
environment, it may cause radio interference. Install and use the
equipment according to the instruction manual.
Warning
Warning
Cisco Catalyst 9136I Series Access Point Hardware Installation Guide
32
Declarations of Conformity and Regulatory Information
VCCI Statement for Japan

Table of Contents

Other manuals for Cisco Catalyst 9136I Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 9136I Series and is the answer not in the manual?

Cisco Catalyst 9136I Series Specifications

General IconGeneral
BrandCisco
ModelCatalyst 9136I Series
CategoryWireless Access Point
LanguageEnglish

Related product manuals