Cisco Catalyst IR1800 Series User Manual

CHAPTER 10
Digital I/O, Ignition, and CAN Bus Connectivity
This chapter contains the following sections:
• Overview of the Digital I/O, Ignition, and CAN Bus Connectivity , on page 73
• Digital I/O Features, on page 73
• Controller Area Network Bus Features, on page 75
• On-Board Diagnostic (OBD-II), on page 76
Overview of the Digital I/O, Ignition, and CAN Bus Connectivity
The connector has four GPIO connections, one Return connection, and one Ignition connection. The Digital
I/O supports both Dry and Wet contacts up to 60 V.
• Dry contact is isolated from a voltage source (or no volt), with an embedded relay function (NPN
transistor), usually used to indicate an event, for example, open/close, alarm.
• Wet contact is a contact with external power (+3.3V to +60V, and a maximum 150mA of current allowed
at high voltage) applied, and is usually used to energize something, for example, solenoid, light.
• Connectivity for the CAN Bus is through two wires on the power connector that connects to the OBD-II
connector of the vehicle.
Digital I/O Features
The common features of Digital I/O are:
• Withstands up to 60V applied at the terminal.
• Protected from reverse voltage and causes no damage to the equipment.
• Digital input and output can coexist on different channels.
• LED Indicator: Provisionable; On: Active, Off: Non-active.
• 4kV surge protected (IEC 61000-4-5).
The Digital I/O Connector
The following figure shows the connector.
Cisco Catalyst IR1800 Rugged Series Router Hardware Installation Guide
73

Cisco Catalyst IR1800 Series Specifications

General

Brand	Cisco
Model	Catalyst IR1800 Series
Category	Network Router
Language	English