© 2004 Boson Software, Inc. All Rights Reserved. 63
Network Designer - Connecting Ethernet Between Devices
Manually connecting Ethernet between Devices
Note: If using the Add Connector Wizard, select Ethernet to be guided through the process.
1. Left-Click on the Ethernet connection to add.
2. The New Connection box will appear, listing all Devices that have Ethernet ports correlating
to the Ethernet connection type that was selected.
3. Select a Ethernet-capable Device to connect from the Available Devices box
4. Select an Ethernet interface from the Interfaces box.
5. Repeat process for other devices
6. Click Finish when done.