CHAPTER 7
Safety Guidelines and Warnings
• Safety Instructions, on page 33
Safety Instructions
Translated versions of the following safety warnings are provided in the translated safety warnings document
that is shipped with your AP. The translated warnings are also available in the Translated Safety Warnings
for Cisco Catalyst Access Points, which is available on Cisco.com.
IMPORTANT SAFETY INSTRUCTIONSThis warning symbol means danger. You are in a situation
that could cause bodily injury. Before you work on any equipment, be aware of the hazards involved
with electrical circuitry and be familiar with standard practices for preventing accidents. Use the
statement number provided at the end of each warning to locate its translation in the translated safety
warnings that accompanied this device.SAVE THESE INSTRUCTIONS Statement 1071
Danger
Read the installation instructions before using, installing or connecting the system to the power source.
Statement 1004
Danger
This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that
the protective device is rated not greater than 20A. Statement 1005
Danger
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Danger
In order to comply with FCC radio frequency (RF) exposure limits, antennas should be located at a
minimum of 16.14 inches (41 cm) or more from the body of all persons. Statement 332
Danger
Cisco Catalyst Wireless 9164I Series Wi-Fi 6E Access Point Hardware Installation Guide
33
To Next Page
Loading...
Need help?
General
