EasyManuals Logo
Home>Cisco>Wireless Access Point>CW9166D1-ROW

Cisco CW9166D1-ROW Installation Guide

Cisco CW9166D1-ROW
62 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #52 background imageLoading...
Page #52 background image
2. This device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the
following measures:
Reorient or relocate the receiving antenna
Increase separation between the equipment and receiver
Connect the equipment to an outlet on a circuit different from which the receiver is connected
Consult the dealer or an experienced radio/TV technician
Professional Installation is recommended
Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate this equipment.This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation.This
device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or
transmitter. For product available in the USA/Canada market, only channel 1~11 can be operated. Selection
of other channels is not possible.FCC regulations restrict the operation of this device to indoor use only. The
operation of this device is prohibited on oil platforms, cars, trains, boats, and aircraft, except that operation
of this device is permitted in large aircraft while flying above 10,000 feet.Operation of transmitters in the
5.925-7.125 GHz band is prohibited for control of or communications with unmanned aircraft systems.
Caution
VCCI Statement for Japan
This is a Class B product based on the standard of the Voluntary
Control Council for Interference from Information Technology
Equipment (VCCI). If this is used near a radio or television receiver
in a domesticenvironment, it may cause radio interference. Install and
use the equipment according to the instruction manual.
Warning
Warning
Access Point Models:
CW9166D1-Q
Cisco Catalyst Wireless 9166D1 Series Wi-Fi 6E Access Point Hardware Installation Guide
44
Declarations of Conformity and Regulatory Information
VCCI Statement for Japan

Table of Contents

Other manuals for Cisco CW9166D1-ROW

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco CW9166D1-ROW and is the answer not in the manual?

Cisco CW9166D1-ROW Specifications

General IconGeneral
BrandCisco
ModelCW9166D1-ROW
CategoryWireless Access Point
LanguageEnglish

Related product manuals