Cisco IE 3000 User Manual

8-3
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-01
Chapter 8 Configuring SDM Templates
.Displaying the SDM Templates
After the system reboots, you can use the show sdm prefer privileged EXEC command to verify the new
template configuration. If you enter the show sdm prefer command before you enter the reload
privileged EXEC command, the show sdm prefer command shows the template currently in use and the
template that will become active after a reload.
.Displaying the SDM Templates
Use the show sdm prefer privileged EXEC command with no parameters to display the active template.
Use the show sdm prefer [default | qos] privileged EXEC command to display the resource numbers
supported by the specified template.
Step 3
end Return to privileged EXEC mode.
Step 4
reload Reload the operating system.
Command Purpose

Cisco IE 3000 Specifications

General

Brand	Cisco
Model	IE 3000
Category	Switch
Language	English