Cisco IE 3000 User Manual

30-22
Cisco IE 3000 Switch Software Configuration Guide
OL-13018-01
Chapter 30 Configuring Network Security with ACLs
Displaying IPv4 ACL Configuration
Displaying IPv4 ACL Configuration
You can display the ACLs that are configured on the switch, and you can display the ACLs that have
been applied to interfaces.
When you use the ip access-group interface configuration command to apply ACLs to a Layer 2
interface, you can display the access groups on the interface. You can also display the MAC ACLs
applied to a Layer 2 interface. You can use the privileged EXEC commands as described in
Table 30-2
to display this information.
Ta b l e 30-2 Commands for Displaying Access Lists and Access Groups
Command Purpose
show access-lists [number | name] Display the contents of one or all current IP and MAC address access lists
or a specific access list (numbered or named).
show ip access-lists [number | name] Display the contents of all current IP access lists or a specific IP access list
(numbered or named).
show running-config [interface interface-id] Displays the contents of the configuration file for the switch or the
specified interface, including all configured MAC and IP access lists and
which access groups are applied to an interface.
show mac access-group [interface interface-id]
Displays MAC access lists applied to all Layer 2 interfaces or the specified
Layer 2 interface.

Cisco IE 3000 Specifications

General

Brand	Cisco
Model	IE 3000
Category	Switch
Language	English