23
Chapter 4: Setting up and Connecting the USB Network Adapter
Setting Up the Adapter
Wireless-G USB Network Adapter
5. The next screen displays all of the Adapter’s settings. If these are correct, you can save these settings to your
hard drive by clicking Save. Click Next to continue and finish the setup. If these settings are not correct, click
Back to change your settings. To exit the setup, click Exit.
6. After the software has been successfully installed, the Congratulations screen will appear. Click Connect to
Network to connect to your network. Clicking Return to Profiles screen will open the Wireless Network
Monitor’s Profiles screen. For more information about the Wireless Network Monitor, refer to Chapter 5: Using
the Wireless Network Monitor.
Congratulations! Setup is complete.
To check the link information, search for available wireless networks, or make additional
configuration changes, refer to Chapter 5: Using the Wireless Network Monitor.
Figure 4-31: Confirm New Settings
Figure 4-32: Congratulations
To Next Page
Loading...
Need help?
General