Cisco MDS 9132T User Manual

Crossbar4Shelf bracket2
To install the shelf brackets in a Telco rack, follow these steps:
Step 1
Position a shelf bracket inside a rack-mounting post as shown in the above figure and align the screw holes at the front
of the shelf bracket with the holes in the rack-mounting post. Then attach the shelf bracket to the rack-mounting post
using a minimum of four 12-24 or 10-24 screws.
The bottom hole of the shelf bracket should align with the bottom hole of a rack unit on the rack-mounting post
(the hole immediately above the 1/2 in. spacing).
Note
Step 2
Repeat with the other shelf bracket.
Step 3
Verify that the shelf brackets are at the same height (using the level or tape measure as desired).
Step 4
Attach the crossbar to the rear of the shelf brackets as shown in the above figure, using the 10-32 screws.
Installing the Shelf Bracket Kit into a Four-Post EIA Rack
The following figure shows the installation of the shelf bracket kit into a four-post EIA rack.
Figure 11: Installing the Shelf Bracket Kit into an EIA Rack
Cisco MDS 9132T Fibre Channel Switch Hardware Installation Guide
24
Installing the Cisco MDS 9132T Switch
Cisco MDS 9000 Family Telco and EIA Shelf Bracket

Cisco MDS 9132T Specifications

General

Brand	Cisco
Model	MDS 9132T
Category	Switch
Language	English