Replacing a DIMM on an I/O Module
6
Replacing Memory on a Cisco Nexus 7000 Series I/O Module
78-100406-01
Step 16 Align the module to the open I/O slot in the chassis and push the module into the
slot until it makes contact with the midplane.
Step 17 Simultaneously push both ejector levers inward until they come in contact with
the face of the module.
The module should be fully seated in the slot and the captive screws should be
aligned with their holes in the chassis. The EMI gasket should close the gap
between this module and the next module.
Step 18 Screw in the two captive screws to the chassis and tighten them to 8 in-lb (0.9
Nm).
Step 19 Reconnect the copper (1000BASE-T) and fiber-optic (SFP, SFP+, FET, and X2)
I/O modules as explained in the “Connecting an I/O Module” section of the Cisco
Nexus 7000 Series Hardware Installation and Reference Guide.
Step 20 Verify that the module has 8 GB of memory by using the show system resources
command.
Step 21 If you need to replace the DIMM on another Cisco Nexus 7000 Series I/O module,
repeat Steps 2 through 18.
Related Documentation
Cisco NX-OS documentation is available at the following URL:
http://www.cisco.com/en/US/products/ps9372/tsd_products_support_series_ho
me.html
The Release Notes for upgrading the FPGA/EPLD is available at the following
URL:
http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/6_x/epld/epld_rn_
62.html
Release Notes
Cisco Nexus 7000 Series NX-OS Release Notes, Release 6.x
NX-OS Configuration Guides
Cisco Nexus 2000 Series Fabric Extender Software Configuration Guide
To Next Page
Loading...
Need help?
General