Cisco RV 120W User Manual

Cisco Small Business RV 120W Quick Start Guide 3
Mounting the Cisco RV 120W
You can place your Cisco RV 120W on a desktop or mount it on a wall.
Installation Guidelines
• Ambient Temperature—To prevent the device from overheating, do
not operate it in an area that exceeds an ambient temperature of
104°F (40°C).
•Air Flow—Be sure that there is adequate air flow around the device.
• Mechanical Loading—Be sure that the device is level and stable to
avoid any hazardous conditions.
For desktop placement, place the Cisco RV 120W unit horizontally on a flat
surface so that it sits on its four rubber feet.
Wall Mounting
STEP 1 Determine where you want to mount the unit and install two screws
(not supplied) that are 2-7/16 in. apart (approximately 61 mm).
Mounting screws should have a head that is approximately 5.5 mm
in diameter and 2 mm deep, with a shaft that is at least 15.5 mm long
and approximately 3.5 mm wide. (Depending on your mounting
surface, you might require shorter or longer screws, or drywall
anchors.)
Do not mount the screw heads flush with the wall; the screw heads
must fit inside the back of the unit.
STEP 2 With the back panel pointing up (if installing vertically), line up the
unit so that the wall-mount slots on the bottom of the unit line up
with the two screws.
2
195114
Wall
mount
slots
2-7/16

Cisco RV 120W Specifications

General

Brand	Cisco
Model	RV 120W
Category	Network Router
Language	English