Cisco RV110W Wireless-N VPN Firewall 3
Back Panel
RESET Button—The RESET button has two functions:
• If the Cisco RV110W is having problems connecting to the Internet,
press the RESET button for at least 3 but no more than 10 seconds with
a paper clip or a pencil tip. This is similar to pressing the reset button on
your PC to reboot it.
Power The Power light is green to indicate the unit is
powered on. The light flashes green when the
power is coming on.
WPS The Wi-Fi Protected Setup (WPS) button is
used to configure wireless access for devices
in your network that are WPS-enabled. See the
Administration Guide
or Device Manager help
page for more information.
WAN The WAN (Internet) light is green when the
Cisco RV110W is connected to the Internet
through your cable or DSL modem. The light is
off when the Cisco RV110W is not connected
to the Internet. The light flashes green when it
is sending or receiving data
Wireless The Wireless light is green when the wireless
module is enabled. The light is off when the
wireless module is disabled. The light flashes
green when the firewall is transmitting or
receiving data on the wireless module.
LAN Ports The numbered lights correspond to the LAN
ports on the Cisco RV110W.
If the lights are continuously lit green, the Cisco
RV110W is connected to a device through the
corresponding port (1, 2, 3, or 4). The light for a
port flashes green when the firewall is actively
sending or receiving data over that port.